Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
Is this the right setup?
I am debating and debating over amps. My latest thoughts is thus:
Use the amp in the Apline 9815 to power the rear full range speakers. Then have a JL Audio 500/5 power a Boston Acoustics Pro (BAP) 12.5LF sub with the 250 W RMS, the BAP 6.5" midbasses in the doors with the 100 W RMS x 2, and the 4" and tweeter on the dash with the 25 W RMS x 2. I am going to play with it, but I am currently thinking that I will want to run the 4" down to around 200 Hz. My real concern is the 25W RMS on the 4". Is 25 W RMS enough for them? I am sure that I could turn the gain down on the 100 W RMS channels, but what is the point in the 100 W RMS if I am only going to be using 35 of it? Obviously I am clueless. Can someone chime in here and give me some advice Sam |
Reply |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Indoor/Outdoor setup question... | General | |||
source amplification question for my new setup | General | |||
Think i have my system setup picked out, need last minute advise tho | Car Audio |