[[email protected]]

KC Stereo Mounts enable owners to accurately set up a stereo pair of
microphones while only having to use one shockmount:

NOS 30cm 90 degrees
DIN 20cm 90 degrees
DINa 17cm 90 degrees
ORTF 17cm 110 degrees
ORTFw (wide) 25cm 110 degrees
Vertical address with both 17cm and 20cm at 0 degrees
MidSide at 0 degrees
Omni with three openings: 20", 17", and 14" at 0 degrees


If you are intersted, please email me at Louie.Liokis @ gmail.com make
sure you state KC Mount in the subject line

The hardest mount to make is the omni bar, so it went first to see if
it was even possible. Looks like you can run 2 pairs of mics with no
problem. I am going to sell them with a bag of washers to ensure a
snug fit The V bar is going to look the same but just shorter and with
holes drilled at 17 and 20

Pictures:
OMNI
http://i140.photobucket.com/albums/r...er/Omni002.jpg

http://i140.photobucket.com/albums/r...er/Omni004.jpg

http://i140.photobucket.com/albums/r...er/Omni014.jpg

Update 2/4/09
The Vertical Address and M/S mounts are completed.

http://i140.photobucket.com/albums/r...andMSMount.jpg

with mics in

MidSide - which does require rubber seals to make it tight.
http://i140.photobucket.com/albums/r...KCMount004.jpg

http://i140.photobucket.com/albums/r...KCMount009.jpg

http://i140.photobucket.com/albums/r...KCMount010.jpg

Vertical Address Bar
20CM
http://i140.photobucket.com/albums/r...KCMount017.jpg

17CM
http://i140.photobucket.com/albums/r...KCMount020.jpg