Reply
 
Thread Tools Display Modes
  #1   Report Post  
Posted to rec.audio.high-end
[email protected] skybuck2000@hotmail.com is offline
external usenet poster
 
Posts: 50
Default "HDMI with ethernet" feedback into DVI blowing up monitor ?

Hello,

Here is a short question for you:

Is it possible for an asus GT 520 graphics card to cause a "over-voltage" feedback from "HDMI with ethernet cable" to "DVI cable" to monitor

Setup was as follows:

PC with GT 520 -- HDMI with ethernet -- a/v receiver
PC with GT 520 -- DVI -- Monitor

So is it possible the receiver send back a audio/video signal to the GT 520, which then abusively added it to the DVI signal, causing over-voltage in the DVI signal to the monitor, basically blowing up/damaging the monitor ?!?!?!?

Bye,
Skybuck.
Reply
Thread Tools
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
"headphone amp" or "personal monitor" [email protected] Pro Audio 13 March 14th 14 05:25 PM
Volume Level of "Tuner" vs that of "CD" "Tape" or "Phono" on my homestereo, boombox, or car receiver ChrisCoaster Tech 10 June 14th 11 10:05 PM
Novel? Guitar amp input stage, single 12AX7, footswitchable using"folded" feedback loop. Morris Slutsky Vacuum Tubes 34 January 25th 10 07:16 PM


All times are GMT +1. The time now is 11:02 PM.

Powered by: vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AudioBanter.com.
The comments are property of their posters.
 

About Us

"It's about Audio and hi-fi"