![]() |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Finally, work has seemed to slow down and I am planning on installing my
Rockford Fosgate 25 to Life Power 1000 in my 2006 Mustang GT in stages over the weekend. The only problem I have run across thus far is that I was planning on mounting the amp to one of the fold down rear seats. Well, the amp is too big, so it looks like I am going to have to mount it to BOTH rear seat backs. I hope this sounds good because this will be the final complete system: Alpine CDA-9885 Infinity Kappa 682s all around A single Solobaric L5 in the Kicker enclosure wired for 2 ohms The 5 Channel Power 1000 For now, I am retaining the Shaker 500 8" "subwoofers" in my doors. I intend to tune the crossover points and gains by ear and I will use the built-in 28 hz Subsonic Filter. The only questions I have right now are 1. Should I pick 100 hz as my starting High/Low pass point or go lower than that? 2. Besides difficulty in folding down the rear seats, do you see any disadvantage to mounting the amp to both rear seat backs? 3. How long before I need Dynamat? |
Ads |
#2
|
|||
|
|||
![]()
hum i decided too look it up n see what all the big deal is...for $500.
i have 3 cali profile amps....1 is 75rmsx4. the other 2 are 100rms x2. total price $275. i think those 3 would bury that rf. n i know ya run it at 2ohm.lol but as any1 knows running amps at lower loads shorten its life. n raises the noise in the music. good luck.... |
#3
|
|||
|
|||
![]()
bob wald wrote:
> hum i decided too look it up n see what all the big deal is...for $500. > i have 3 cali profile amps....1 is 75rmsx4. the other 2 are 100rms x2. > total price $275. > i think those 3 would bury that rf. > n i know ya run it at 2ohm.lol > but as any1 knows running amps at lower loads shorten its life. n raises > the noise in the music. > good luck.... > Yeah, but I wanted to do it with ONE amp this go round. Crap, you just reminded me that all of my channels are going to be at 2 ohms too.... I forgot about the Infinity Kappas.... Regardless, the total cost of this system is less than the factory Shaker 1000 option. Oh well, my break is over, back to the car! - Chris |
#4
|
|||
|
|||
![]()
I own a 1000 25 to life & I set my High Pass @ 85-90 hz running 6.5 morel. Try that out. Good luck
|
#5
|
|||
|
|||
![]()
DYNAMAT ASAP
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rockford fosgate T2 | [email protected] | Car Audio | 1 | July 9th 06 07:47 PM |
rockford fosgate | Chris Pueschel | Car Audio | 0 | April 15th 05 12:35 AM |
Pop / Thump with Nissan factory Rockford Fosgate amp and aftermarket Rockford Fosgate head unit | [email protected] | Car Audio | 0 | August 28th 04 01:28 AM |
FS: Rockford Fosgate 800.4 | Rob K. | Car Audio | 1 | November 20th 03 09:46 PM |
< |
Dirt Cheap | Car Audio | 0 | November 14th 03 01:51 PM |