[David O'Heare]

Just in case somebody's interested:

Now that the St. Patrick's Day marathon has quieted down, I finally got a
chance today to spend some time with my 01V that went dead on me. I found
information on the fix for a ground problem, and made sure that that wasn't
the issue. I then plugged a bunch of microphones into it, fed them signal
and ran it for a couple of hours, worked fine.

Then sat down for a bit of playing music with a couple of good friends, and
it went quiet on me again.

Just for completeness' sake, the board goes quiet (no output on the main XLR
outs, omni outs, or headphone out) when both effects processors are on, and
at least one is running the Hall Reverb, and the board has been on for long
enough to warm up thoroughly. Turning off either effects processor brings
the audio back. Turning the processor back on works for a couple of seconds,
then there's a low-level noise that rises in pitch for about a second on the
outputs, and then nothing. Oh, and the LED meter ladder goes up to -9 and
stays there while there's no output.

Yes, Mike, it's off to the doc tomorrow for a transplant.

And if anyone cares, I'll report on the repair when it's done.

Dave O'Heare
oheareATmagmaDOTca