Home |
Search |
Today's Posts |
#1
Posted to rec.audio.pro
|
|||
|
|||
Further on Yamaha 01V with no output
Just in case somebody's interested:
Now that the St. Patrick's Day marathon has quieted down, I finally got a chance today to spend some time with my 01V that went dead on me. I found information on the fix for a ground problem, and made sure that that wasn't the issue. I then plugged a bunch of microphones into it, fed them signal and ran it for a couple of hours, worked fine. Then sat down for a bit of playing music with a couple of good friends, and it went quiet on me again. Just for completeness' sake, the board goes quiet (no output on the main XLR outs, omni outs, or headphone out) when both effects processors are on, and at least one is running the Hall Reverb, and the board has been on for long enough to warm up thoroughly. Turning off either effects processor brings the audio back. Turning the processor back on works for a couple of seconds, then there's a low-level noise that rises in pitch for about a second on the outputs, and then nothing. Oh, and the LED meter ladder goes up to -9 and stays there while there's no output. Yes, Mike, it's off to the doc tomorrow for a transplant. And if anyone cares, I'll report on the repair when it's done. Dave O'Heare oheareATmagmaDOTca |
Reply |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Is there an output meter that shows a digital display of output wattage? | Pro Audio | |||
FA:Original Yamaha NS10m's, Yamaha sub NS-W2, dbx, Oktava closing soon | Pro Audio | |||
FA: Yamaha CD8-TDII Card - Yamaha Digital Mixers <-> TDIF Gear | Pro Audio | |||
Signal Output Routing Question for Yamaha 01v w/ADAT card | Pro Audio |