Home |
Search |
Today's Posts |
#1
|
|||
|
|||
New Subs... Need a amp
What i have is
2 10" RF RFP4410 (Not Punch) 200w RMS SVC What Amp should i use with this Sub? I was thinking the P300.1BD .... Thx/// Last edited by jimbo_limited : July 13th 06 at 04:20 AM |
#2
Posted to rec.audio.car
|
|||
|
|||
4 Subs and an Amp
"jimbo_limited" wrote in message ... What i have is 2 12" RF Punch 2 200w RMS 2 10" RF RFP4410 (Not Punch) 200w RMS And a Pyle 4-Channel 1400w 175w x 4 @ 4 Ohms Can i wire them to each channel and run them safely or should i buy another amp? -- jimbo_limited That is what i would do..... Make sure they are in phase.... |
#3
|
|||
|
|||
With the P300.1BD amp, Rockford under-rates their amps, I'll look through a lot of amps and find one that puts out over 400w RMS @ 2 Ohm and buy that one.
Their Amps are Rated with a voltage rating of 14.4 Volts... Which CARS dont run that. My vehical runs at 13.8 Volts with no A/C and 13.3 Volts with A/C Full Crank. That would allow the Amp to put out over 380w+.... Or should i just spend $100 Bucks more for 200w+ more. P600.1BD. |
Reply |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
I have a 88 Oldsmobile Custom cruiser... Looking for Subs... | Car Audio | |||
wiring options for 2 subs (2 omhs vs 4 ohms) | Car Audio | |||
Why arent my friends subs very loud??? | Car Audio | |||
just bought some subs...questions/concerns.... | Car Audio | |||
Alpine deck blew my subs! | Car Audio |