Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
What do these freq response and xover specs mean?
I think what they mean is that it will put out 36Hz -120 Hz, +/- 3dB.
Outside if this range, the output might vary more than +/- 3dB. This is rather confusing. ~James. ) "hoarse with no name" wrote in message ... http://www.velodyne.com/velodyne/pro...ecs/VX-10.html "Crossover: Variable from 50-200 Hz Frequency Response: 36-120 Hz, +/- 3dB" Does frequency response mean the possible frequency range? If so, then why would the variable crossover allow you to choose a crossover point higher than the highest frequency in the frequency response figures? |
#2
|
|||
|
|||
"James Lehman" wrote in message o.verio.net... "hoarse with no name" wrote in message ... "Crossover: Variable from 50-200 Hz Frequency Response: 36-120 Hz, +/- 3dB" Does frequency response mean the possible frequency range? If so, then why would the variable crossover allow you to choose a crossover point higher than the highest frequency in the frequency response figures? I think what they mean is that it will put out 36Hz -120 Hz, +/- 3dB. Outside if this range, the output might vary more than +/- 3dB. Correct. And you will simply be rolling off the higher response slope even further with the crossover, dependant on its setting. This is rather confusing. Not at all. Why do you think so? MrT. |
#3
|
|||
|
|||
On Sat, 27 Aug 2005 19:01:09 -0700, hoarse with no name wrote:
http://www.velodyne.com/velodyne/pro...ecs/VX-10.html "Crossover: Variable from 50-200 Hz Frequency Response: 36-120 Hz, +/- 3dB" Does frequency response mean the possible frequency range? If so, then why would the variable crossover allow you to choose a crossover point higher than the highest frequency in the frequency response figures? I believe this means that they bought their amplifier/crossover subassembly from outside, and this one was the cheapest. It wsould have cost money to change the crossover limits, so they didn't bother. d |
#4
|
|||
|
|||
"hoarse with no name" wrote in message
... http://www.velodyne.com/velodyne/pro...ecs/VX-10.html "Crossover: Variable from 50-200 Hz Frequency Response: 36-120 Hz, +/- 3dB" Does frequency response mean the possible frequency range? If so, then why would the variable crossover allow you to choose a crossover point higher than the highest frequency in the frequency response figures? In HT applications, you can use the processor's crossover setting (usually 80 Hz), and then set the subwoofer's to '200 Hz' so it's 'out of the way' |
#5
|
|||
|
|||
Gary,
In HT applications, you can use the processor's crossover setting (usually 80 Hz), and then set the subwoofer's to '200 Hz' so it's 'out of the way' That explanation gets my vote too. And that's how my Carver Sunfire sub is set up. --Ethan |
Reply |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
AR9 speakers from about 1980. | Vacuum Tubes | |||
Transient response of actively filtered speakers | Tech |