Home |
Search |
Today's Posts |
#11
Posted to rec.audio.tubes
|
|||
|
|||
Restoring a Sherwood S-5000
OK, here are the stats. The main filter cap has been replaced with another can. Others have been replaced underneath.
Link to pics: https://www.dropbox.com/sh/zoqcrtzbmn1saha/JxXYbkaIIc C1/a 472VDC C1/b 470VDC C1/c 388VDC C2/a 301VDC C2/b 217VDC A lot higher than what you had, and what specs show! No wonder the 6BQ5's I originally tried for power amps were arcing. There is an additional cap (see it in the C1 photo, to the right of the can) that has 46VDC on it. Bias caps; These have been replaced, so my measurements are left to right as viewed in the pic: -26.6vdc, -34.5vdc, -26.1vdc As for the DC filiment voltages, the only one I found was 13.3VDC on the first two 12AX7's where is the 24V supposed to be? Selineium rectumfryers have been replaced with diodes, see pic. Tubes are as follows from the top, Left to right nearest the front: three Telefunken 12ax7, two Tesla ecc803s. Adjacent the filter cap are two RCA 7199. I will note that the phono hum seemed to be less on my workbench than in the workshop that I am using the amp, not sure if that is because of smaller speakers, or lack of 8-ft flourescent lights above, or just power situations. But, it is still there. The amp is quite silent on FM input (used for my iPod) --JRC |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Loud buzz on Sherwood S 5000 | Tech | |||
Sherwood S-5000 II Integrated Amplifier | Vacuum Tubes | |||
WTB: Sherwood 5000 parts | Marketplace | |||
WTB: Sherwood 5000 parts | Vacuum Tubes | |||
Sherwood S-5000 II Question | Vacuum Tubes |