Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Kenwood KDC-x717 CD problem
It normally turns the faceplate out when I start the car and turns it back
when I turn off the engine. Recently, the faceplate is able to come out but after few seconds, it will go back automatically. Sometimes it is stuck in the half way back. I took it out and couldn't find any connection problems. The manual says the fuse may be blown. If this is true, there should be a short circuit inside the CD. Has anybody gotten the same problem before? If it is the fuse problem, need I do something else after change a new fuse? |
#2
|
|||
|
|||
Most of the time when I've seen that problem it is the ribbon cable that
connects the flip-face to the main PC board. Over time (usually about 1 to 1-1/2 years) the cable gets breaks in it from bending back and forth. "Gang Xin via CarKB.com" wrote in message ... It normally turns the faceplate out when I start the car and turns it back when I turn off the engine. Recently, the faceplate is able to come out but after few seconds, it will go back automatically. Sometimes it is stuck in the half way back. I took it out and couldn't find any connection problems. The manual says the fuse may be blown. If this is true, there should be a short circuit inside the CD. Has anybody gotten the same problem before? If it is the fuse problem, need I do something else after change a new fuse? |
Reply |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Weird problem with vintage Kenwood KA-8100 integrated amp | Tech | |||
Some Recording Techniques | Pro Audio | |||
CLC: More | Vacuum Tubes | |||
Kenwood KDC-MP919 Problem.... | Car Audio |