[James]

I am putting new front speakers in Mod Pod enclosures, to be mounted on the
floor, adjacent to the bottom portion of the door frame. On the driver's
side, near the bottom edge of the door, there is a plastic wire guard
assembly, which runs from almost underneath the dash, to the point near the
back of the driver's seat. This wire guard protects the bundle of wires
that go to the rear of the Jeep for various things like taillights, etc.
The Mod Pod enclosure will not fit on the left side, without moving this
wire guard, and trimming it for a proper fit. Along the back-end edge
alongside the driver's seat, there are several phillips screws which of
course are no problem to remove. However, at the front of this wire guard
assembly, nearly underneath the dash, there is a hole , with a screw mounted
in the center. No nut to loosen, just a screw, and I see no way to detach
this end of the wire guard from the vehicle.

Do any of you know what I am talking about, and how I can remove this wire
guard ?? HELP, I am STUCK, and I can't GET MY MOD POD INSTALLED !!!

Thanks for any tips !! Remember, 2002 Jeep Wrangler.

James