[Ron Kremer]

hello RAT's,

I bought an US version of the LEAK Stereo 20 which has only mains taps for 110 -
117 and 124 Volt. I'm looking for an original LEAK transformer with 200/210,
220/230 and 240/250 V taps as was used in the same model for non- American
markets.

I'm prepared to buy but (part) swap is preferred; so if there is anybody in the
US, Canada or Japan with a 'wrong' Stereo 20 this is the chance to aquire the
right mains transformer.

Offers are invited stating condition and price including the costs for shipment
to the Netherlands.

Thanks & best regards, Ron




Ron Kremer

[Tonni[_2_]]

"Ron Kremer" skrev i en meddelelse
...
hello RAT's,

I bought an US version of the LEAK Stereo 20 which has only mains taps for
110 -
117 and 124 Volt. I'm looking for an original LEAK transformer with
200/210,
220/230 and 240/250 V taps as was used in the same model for non- American
markets.

I'm prepared to buy but (part) swap is preferred; so if there is anybody
in the
US, Canada or Japan with a 'wrong' Stereo 20 this is the chance to aquire
the
right mains transformer.

Offers are invited stating condition and price including the costs for
shipment
to the Netherlands.

Thanks & best regards, Ron




Ron

Maybe there would be some luck at http://groups.yahoo.com/group/hjleak

Best of luck!

Tonni

[Patrick Turner]

Ron Kremer wrote:

hello RAT's,

I bought an US version of the LEAK Stereo 20 which has only mains taps for 110 -
117 and 124 Volt. I'm looking for an original LEAK transformer with 200/210,
220/230 and 240/250 V taps as was used in the same model for non- American
markets.

I'm prepared to buy but (part) swap is preferred; so if there is anybody in the
US, Canada or Japan with a 'wrong' Stereo 20 this is the chance to aquire the
right mains transformer.

Offers are invited stating condition and price including the costs for shipment
to the Netherlands.

Thanks & best regards, Ron

Ron Kremer



If you cannot source a genuine Leak tranny, which would be
scarce as rocking horse droppings, why not try a Hammond
with about the same voltages.

http://www.hammondmfg.com/300series.htm

look down the list at 372JX

The 300-0-300 HT winding should give about +330V with a tube rectifier.

Maybe its a better Xformer than the original Leak.

Patrick Turner.

[Sander deWaal]

Patrick Turner said:


If you cannot source a genuine Leak tranny, which would be
scarce as rocking horse droppings, why not try a Hammond
with about the same voltages.

http://www.hammondmfg.com/300series.htm

look down the list at 372JX

The 300-0-300 HT winding should give about +330V with a tube rectifier.

Maybe its a better Xformer than the original Leak.


I'm pretty sure it is.
Especially while the mains voltage overhere is about 230V, the old
trannies are 220 or 240V.

However, to keep the appearance of the amp intact, one will need the
same cover/end bell. That's the hard part.

--

- Maggies are an addiction for life. -