Home |
Search |
Today's Posts |
#1
|
|||
|
|||
input sensivity / headroom on amplifier
hi
i've a question about the input sensitivity of the amplifier electrovoice P3000 data sheet EvP3000: www.electrovoice.com/electrovoice/EVfiles.nsf/lookup/P3000/$File/p3000-eds.p df ( ..../p3000-eds.pdf ) input sensitivity=0dbu (0,775 Vrms) maximum input level=+20 dbu (7,75 Vrms) i have two meter before the amplifier input: -Rms Vu meter that display 0dbVU whit a 1 khz sine @ 0 dbu (max display=+3dbVU) -Peak led meter that display 0db whit a 1 khz sine @ 0 dbu (max display=+24db) i work in live (much peak and not much rms), so i wish to put a maximizer/compressor @ L/R, after the maximizer a RMS limiter (set@0 dbu), and after all a peak limiter (set@+19 dbu).... ..... al before the meter (Vu and Peak), so i can keep under control in every time the signal that go to the EvP3000, a signal where the rms don't go up 0dbVu and peak don't go up +19db. what did you think about this? is a correct way to take the full 1200Wrms @4ohm from the Ev3000 without distorsion, or a stupid way to crash all the system? thank's a lot, and excuse my very bad english. marco |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
rec.audio.car FAQ (Part 2/5) | Car Audio | |||
rec.audio.car FAQ (Part 1/5) | Car Audio | |||
FS: SOUNDSTREAM CLOSEOUTS AND MORE!! | Car Audio | |||
What is a Distressor ? | Pro Audio | |||
Passive Volume Control (Passive Preamp) Info | High End Audio |