|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 23rd 08, 12:12 PM
|
|||
|
|||
wanted: SME tonearm cartridge shells
SME tonearm cartridge shells (or equivalent) They don't have to be "NOS" but should be intact, including the lift handle.
Thanks 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WANTED fidelity research 66 or any 12" tonearm | immortalsound | Vacuum Tubes | 0 | October 7th 06 05:34 AM |
| Wanted: Tonearm cable or just the connector; Profile arm information | pj | Marketplace | 0 | September 6th 06 12:18 PM |
| effective mass tonearm Sony PS-X50 wanted | Thomas Ludwig | Tech | 1 | September 24th 04 08:39 PM |
| B&O mmc 4 cartridge wanted | Dave | Marketplace | 0 | December 6th 03 09:21 PM |
| Wanted: Older ADC XLM type cartridge | Mike | Vacuum Tubes | 0 | July 25th 03 01:06 AM |
Linear Mode
