need help to set up a M-Audio Audiophile 2496
Bernard wrote:
Hi to Everyone,
Could someone help me managing my new audio card ?
It operates under Debian Linux, but I also tested it under Windows XP,
with same results. The input volume for digitilizing vinyl records is too
low, and I can't enhance it. On the contrary, with my old audio card that
was part of my ASUS motherboard, I was getting to high input volumes and I
had to lower the input to 7 to 13% of the maximum so as to avoid
saturating, such low settings were not in the green area for recording.
Here is what I get with Alsamixer :
Alsamixer v1.0.13
Card: M Audio Audiophile 24/96
Chip: ICE 1712 - multitrack
View: Playback Capture [All]
Item : list follows:
Item: IEC958 set on H/W In 0
Item: IEC958 Multi. Was in 'L CAPTUR R' mode, but I de-activated it, to no
avail. I am not in multichannel mode, only in stereo.
Item: IEC958 Multi 1: same thing
Item: IEC958 1 set to 'H/W In 1'
other options for IEC958 et IEC958 1 were H/W In 2 ... H/W In 7,
IEC958 In L, IEC958 In R, PCM Out, Digital Mixer.
Item: ADC (Analog to Digital Controller ??) set to 55%, dB gain =
-18.5 (in the green area)
Item: ADC1: idem : dB gain=-18.5
Item: ADC Capture. dB gain=-23 (in the green)
Item: ADC1 Capture. dB gain=-23 (in the green)
Item: DAC (Digital to Analog Controller ??) dB gain=-23 idem
Item: DAC Capture -23 dB
Item: DAC1 -23 dB
Item DAC1 Capture -23 dB
Item: Deemphasis. Set to 48 kHz. Other options : 32, 44.1,
OFF
Item: H/W set to H/W In 0
Item: H/W1 set to H/W In 1
other options : H/W In 2, H/W In 3,
... H/W In 7, IEC958 In L, IEC958 In R
Item: H/W Multi L CAPTUR R CAPTUR de-activated
Item: H/W Multi1 L CAPTUR R de-activated
Items: Multi, Multi1, Multi2... Multi9 set to Mute (MM)
Item: Multi Track Internal Clock : 44100
Item: Multi Track Internal Clock Default : 44100
Item: Multi Track Peak 5656
Item: Multi Track Peak 6969 (two homonymous items, same for the next two)
Item: Multi Track Peak. Here a single figure : 69
Item: Multi Track Peak. Same thing, 69
Item: Multi Track Capture. Set to 86, against my will. The green area
starts at 39, but if I rise the setting, it comes back to low values after
restarting 'alsamixer'. True enough, I am not in multichannel mode, so
chances are that this setting is obsolete here.
Items: Third and fourth 'multi track peak'
Item: Multi Track Rate Locking. 2 options : Mute ou 00.
Item: Multi Track Rate Reset: idem
Item: Multi Track Volume Rate : 67
Thanks in advance for comments and advises.
Bernard, you are treading a well worn path. I have been doing what you
describe for a number of years with a moving coil cartridge, NAD PP2 pre
amp and the software levels set at max. Regardless of operating system,
I use my analog mixer between the pre amp and M-Audio card to raise the
level and often to raise the treble slightly.
Best wishes,
Alan.
|