View Single Post
  #5   Report Post  
Posted to rec.audio.tech,sci.electronics.repair
martin martin is offline
external usenet poster
 
Posts: 1
Default Vintage Pioneer SX-838 receiver - UPDATE

On May 27, 5:57*am, Readily Visible wrote:
When I put the top and bottom back on the unit and plugged in all the
various RCA plugs and speaker wires and 300 ohm antenna, the same
problem reasserted itself, the left channel bugged out.

Then I pulled the top and bottom and set the unit up on its side and it
has been playing all day without a hitch.

So I am thinking the problem is either heat related or position related.

As far as position related goes, this time the unit is standing up on
the opposite side as before, so I think the problem is heat related. As
long as the top and bottom are off, the left channel does not go out.
That makes a problem because as long as the problem does not assert
itself with the top and bottom off I cannot poke and prod and measure.

Got it!

I will simply leave the top and bottom off and put the unit on its side
and live with it.


Gosh this is one you want in front of you, I have been reading the
posts to this and thought I would throw in my half pennys worth. When
I first read your description I was going to say get out freezer
spray, but the fact it started working for hours after cleaning relay
contacts - makes me suspicious of them still. Maybe others will have
same experience, if they are not big meaty relays often cleaning is
not good enough, and replacement is only sure fire way of making good
repair. If you are feeling adventurous you could bridge across relays
- to eliminate them from being the problem, until you have found
fault. Remember it is a hazard if left open no kids near please.
Regards Martin