Mackie 32-8-2 mixer
Joseph wrote:
I hooked it up and I've been running it interfaced to my daw through my del=
ta 1010. It does what I need it to do and sounds pretty good. Thinking abou=
t pulling out my Tascam 38-8 now that I have a mixer again. Anyone know any=
one who still works on those (the Tascam)? If I remember right, it needs a =
drive belt replaced.
It needs drive belts, a new pinch roller, a rough alignment and it _likely_
needs some of those conductive rivets resoldered after so long. Plenty of
techs will work on them, even Tascam service.
Get a new alignment tape too, since your alignment tape has likely gone out
of spec after so long.
--scott
--
"C'est un Nagra. C'est suisse, et tres, tres precis."
|