View Single Post
  #3   Report Post  
Don Joe
 
Posts: n/a
Default

Thanks, Mark. The speakers are not sealed off well and the doors could
use some additional Dynamat-like material so I will try that first.
Thanks for the other ideas.

Don

On Sun, 29 Aug 2004 22:30:33 -0400, MZ wrote:

A resistor will attenuate broadband... unless you're somehow able to
install it on the tweeter itself, but not all coaxials will support this
very easily. You could always consider low-passing the speaker by placing
the appropriate size inductor in series with the speaker.

But an easier solution may be to look at the installation of the driver.
Are you sure that you're getting the optimal amount of midbass for the
driver? If it's not installed optimally, it can lead to a degradation in
midbass performance. Look for a solid mounting - no leaky panels, no gaps
between the mounting flange and the mounting surface, etc. If you're sure
that it's ok, then the next step may be to consider repositioning the
drivers so that they're angled more off-axis.

Another solution would be to try to attenuate the high frequencies by
putting a layer of foam on the underside of the speaker grilles, or a piece
of foam or tissue paper over the tweeter specifically.

Sometimes, speakers that aren't amplified also exhibit the kind of symptoms
you describe. Maybe an amplifier is in order if you don't have one already.

Then there's always the possibility that it's just not the right speaker for
you. IME, Kicker speakers in general have always seemed a bit bright and
lacking in midrange.