coreybenson wrote:
Picked up a used Yamha 01V mixing console for $350. Channel 11 has
issues. It will not allow any signal to pass until it hits about 80%
of the fader (as you fade to the top of the fader), then it comes in
full force. It also won't move (motorized) through the section where
it won't register.
Did you try a fader calibration?
Hold "enter" while switching the unit on, then it should calibrate the
faders.
If that does not work just replace the fader.
sebastian
--
"Kaffee? Du sagst Kaffee dazu? Das war hochraffiniertes
Industrie-Koffein in einer kandiszuckergepufferten Lösung."
-- Dietz Proepper in d.a.s.r.
Die Partyband vom Niederrhein:
http://www.stimmtso.net