"west"
Why do Dynaco Amps and even Uncle Ned's schematic of a Hi Power
Williamson
Amp use the 16ohm OPT tap instead of the 8ohm for feedback?
** The former industry standard for hi-fi loudspeakers was 16 ohms - so
most designs were optimised for this load. It only became 8 ohms ( or
lower ) with the advent of output transformer-less SS amplifiers. The 16
ohms tap also gives the highest voltage level.
What would
happen if you took a stock ST-70 or MKIII and moved the feedback over to
the
8ohm?
** You will get about 3dB more gain and 3dB more THD.
............ Phil
|