On Thu, 20 May 2021 11:30:12 -0700, Tobiah
wrote:
On 5/19/21 2:17 PM, Tobiah wrote:
I recorded two mono channels, each through a different preamp into the same
audio interface.Â* I normalized those, then arranged the results as A/B/A/B
into the same sound file.
All things were as equal as I could make them, other than the preamps.
Can you detect a difference?Â* Do you like one better?
http://ven.rcsreg.com/r2/2_pres.wav
Later, I'll disclose the premps.
Tobiah
It was Two NT1-A's positioned side by side. One went into
a Mackie 1402-VLZ Pro preamp and out the insert into the
line input of a Presonus 1810 inteface.
The second mic went into a preamp of the 1810.
Each was recorded simultaneously onto separate tracks,
then arranged Mackie/Presonus/Mackie/Presonus.
It did sound like you had them quite close to the sound hole, though,
which is not good for balance. I also use NT1-As, and I reckon the
ideal position for recording acoustic guitar is about six feet away.
You need a decent room of course.
d
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus