"mark" wrote in message
...
On Oct 30, 7:59 am, "CJ" wrote:
there are 4 inputs on the back of the NAD 2200 poweramplfier. "LAB"
and "NORMAL" L and R. Neither says mono. There is a switch for bridge
mono which of course i have selected. I thought i'd need to feed both
the L and the R sides of the poweramp the same output from the preamp.
I think what you're suggesting is feeding a single poweramp input
should suffice.
Just found the 2200 service manual online and from looking at the
schematic
you connect the pre-amp to the left input only. 'Normal' input is a freq
limited version of 'Lab' input as previously guessed.
got it, thank you...where did you find the service manual? Thanks
I Googled NAD 2200 manual and found the following link pretty quickly..
http://www.audio-circuit.dk/Schemati...0PE-pwr-sm.pdf