"patric deimon"
I did go in with a multimeter and check the voltages looking for
anomalies between the two sides. Strange, I didn't find any.
Power supply is putting out about 15 volts. Couldn't get anything to
reveal by wiggling or tapping and no visible signs.
I was just checking voltages, not signal, and there seemed to be
voltages as far as I checked. I ran out of time. It has been awhile
since I used my techie brain and it felt like it it had been replaced
with oatmeal.
** Check all the op-amp pins 1 and 7 for large DC voltages - should be only
millivolts.
Any with more than 1 volt DC on those pins are dud.
.......... Phil
|