"Pooh Bear" wrote in message
...
Phil Allison wrote:
"Richard Freeman" ..
"Arny Krueger"
"Chris Breitner"
I have a ribbon mic I'd like to gig with, and the PA systems we
use
normally plug into have an all-channels-on/off for the phantom
power.
Our vocalist uses a condenser mic, so she needs it on. If the
phantom
power hits my ribbon mic, it might permanently damage the ribbon
element.
Does anyone know of a DIY homebrew solution?
Measure the resistance from pin 2 and 3 to pin 1 using an ohm meter
with
limited current, such as a good DVM.. If it is infinity, you don't
have
a
problem, and then stop worrying.
Of course it could have a Transformer isolated output in which case he
could
read a near short and still not have to worry ....
** You better **re-read** what Arny posted - ie test from pins " 2
and
3 to pin 1 " !!!!!!!
Never heard of a centre-tapped transformer as often used in what would now
be
vintage gear ? Nice DC R connecting all the pins.
** Got any idea at all why the ohm meter tests are being suggested at all
?????????????
It would **really ** help if you pulled your fat head out of your bum
prior to posting, Pooh.
................. Phil
|