[[email protected]]

Scott Dorsey wrote:

"That's fine, just don't use two sets of 6 ohm speakers"

Why not? They're above the minimum
stated on the back of his receiver.



"Buy speakers that sound good, don't worry about the impedance. Â*Worry about
how they sound"

Typical 'engineer' statement. Fine:

Remove all impedance specs from
the backs of speakers, receivers, and
amplifiers. While we're at it, remove
signal presence and OL single LED
indicators and all the meters from
DAWs and mixing consoles.

Remove the specifications page
from the website and from the operators
manuals. It doesn't matter right?
Whether to run balanced or unbalanced
lines, whether this component is over
heating, that one is distorting, or the
other one is clipping. As long as it
"sounds good" "Use your ears"!!!

Ave Maria purissmo...