Thread: SET amplifier Q
View Single Post
  #3   Report Post  
Posted to rec.audio.tubes
Phil Allison[_3_] Phil Allison[_3_] is offline
external usenet poster
 
Posts: 500
Default SET amplifier Q





UBT-1 is rated at 160mA on the primary...



** Yep - the total idle current is 110mA.


Did those 300Bs develope a dead short?



** According to the owner/builder - there was a flash / bang / wallop event
and then a dead channel.

One dud 300B draws no bias current while the other draws waaaay to much, the
UBT-1 has an open deep inside but shows no sign of shorted turns.

What has me intrigued, however, is the low THD figures at and near full
power PLUS the fact that 3H dominates.

The test results are far more like a PP class A triode amp than a SE one.

The 6SN7 is running at full gain ( about 18 times per half ) and there is
definitely NO negative feed back - in fact the two speaker windings have
been left floating.



..... Phil