BigBob seemed to utter in news:BOFii.85934$NV3.81765@pd7urf2no:
"Tim Witort" wrote in message
.131...
BigBob seemed to utter in news:LCYgi.71118$NV3.56834@pd7urf2no:
"Tim Witort" wrote in message
.131...
I've had a Carver 2090i amp sitting on the shelf for a few
years after using it in a prior install. It performed very
well for me, so I'm putting it into a new install. I no longer
have the manual for it and can't find anything on the web
about the amp. I want to bridge it to drive a single driver
subwoofer, but there is no switch marked "BRIDGE". The
closest thing is a swtich marked MONO. And the four speaker
terminals have the positive from one channel circled and the
negative from the other channel circled. I would assume that
these are the terminals that will be driven when bridged.
Anyone familiar with Carver amps and if my above assumptions
are correct?
-- TRW
http://www.carverpro.com could help downloads don't seem to be
available for 2090i
Also http://www.carveraudio.com/phpBB2/viewtopic.php?t=3066
http://www.carveraudio.com/phpBB2/vi...=a19688f3fedd5
53 62cd2e30ab0ebc36f
http://www.carveraudio.com/phpBB2/index.php
Thanks. I'll check these out.
More utterances'
http://www.carveraudio.com/manuals.htm
Thanks, but I didn't want to spend $10 for a manual. Most
companies provide downloadable manuals for their products,
but since this is an old Carver car amp, there doesn't seem
to be a free source for this information anywhere.
-- TRW
_______________________________________
t i m . w i t o r t
_______________________________________