http://www.carverpro.com could help downloads don't seem to be available for
2090i
Also
http://www.carveraudio.com/phpBB2/viewtopic.php?t=3066
http://www.carveraudio.com/phpBB2/vi...e30ab0e bc36f
http://www.carveraudio.com/phpBB2/index.php
"Tim Witort" wrote in message
.131...
I've had a Carver 2090i amp sitting on the shelf for a few
years after using it in a prior install. It performed very
well for me, so I'm putting it into a new install. I no longer
have the manual for it and can't find anything on the web
about the amp. I want to bridge it to drive a single driver
subwoofer, but there is no switch marked "BRIDGE". The
closest thing is a swtich marked MONO. And the four speaker
terminals have the positive from one channel circled and the
negative from the other channel circled. I would assume that
these are the terminals that will be driven when bridged.
Anyone familiar with Carver amps and if my above assumptions
are correct?
-- TRW
_______________________________________
t i m . w i t o r t
_______________________________________