In message , Mike Rivers
writes
Another possibility is to get a coupling - a short piece of thick wall
tubing with two set screws - and couple another piece of rod of the
correct diameter to the existing pot shaft. You could cut the shaft off
the old pot that you're replacing and use that as the extension. You
may have to cut off a piece of shaft off the new pot to make room for
the length of the coupling.
I remember those sleeves, with 4 rather than two set screws.
There appear to be pot shaft extenders of various types on both US and
UK ebay.
--
Bill
---
This email has been checked for viruses by AVG.
https://www.avg.com