http://cgi.ebay.com/ws/eBayISAPI.dll...m=3D7349747272

This is a Crown D-75 stereo amp. It can be bridged for mono operation.
It's in great condition, and works perfectly. Here are some specs....
Performance: Frequency Response: =B10.1 dB from 20 Hz to 20 kHz at 1
watt. Phase Response: +10 to -15 degrees from 20 Hz to 20 kHz at 1
watt. Signal-to-Noise: 106 dB from 20 Hz to 20 kHz at full bandwidth
FTC power. Total Harmonic Distortion (THD): Less than 0.001% at full
bandwidth FTC power from 20 Hz to 400 Hz increasing linearly to 0.05%
at 20 kHz. Intermodulation Distortion (IMD): (60 Hz and 7 kHz 4:1) Less
than 0.01% from 0.25 watts to full bandwidth FTC power, and less than
0=2E05% from 0.01 to 0.25 watts. Crosstalk: Greater than 100 dB below
full bandwidth FTC power from 100 Hz to 1 kHz decreasing linearly to 80
dB at 20 kHz. Damping Factor: Greater than 400 from DC to 400 Hz.
Controlled Slew Rate: 6 volts per ms. (Slew rates are limited to useful
levels for ultrasonic/RF protection.) Voltage Gain: (At the maximum
level setting) 20.6:1 =B13% or 26.3 dB =B10.3 dB.

Check my feedback...over 1000 positives !!! Good Luck !!!