Thanks for the suggestions. I was hoping, though, that if I have to raise it, that it would be not
much more than about a half an inch or so. Since the idea is to make my trunk more usable, I don't
want to have this acrylic sticking up several inches off the floor. Also, the higher I raise it,
the more stuff is going to find its way underneath it.
Mr.Lull, my favorite design was actually the one that left the _least_ open space.
I could maybe link to some images of my candidate designs if people are interesting in seeing them.
"I. Care" wrote in message
.net...
In article ,
says...
why not? they aren't solid spacers all the way around the sub. all
he'd need are 3-4 little pegs to stand the grill on, very similar to
the pegs/feet that a downfiring home sub sits on. there would
certainly be room, it's just like a home setup.
I agree. Good logic.
MOSFET
I don't know that I am following this thread correctly, but, my pair of
8" subs for my competition (was) car are down firing and has only about
1" space underneath with no grill. It wasn't set up for SPL but worked
OK for SQ.
--
I. Care
Address fake until the SPAM goes away ;-}