[geoff]

On 6/10/2020 10:46 am, Michael Beacom wrote:
On 2020-10-04 15:21:33 +0000, Ralph Barone said:

Ty Ford wrote:
On Saturday, October 3, 2020 at 9:15:22 PM UTC-4, geoff wrote:
https://www.prosoundweb.com/revealin...io-wire-cable/


geoff

Sadly, some people will actually believe this.

Ty Ford


The part about placing your amplifier above your speakers is clearly
wrong.
In a copper wire, the free electrons each weigh about 118,000 times LESS
than the ions in the stationary copper lattice. Because of this,
electrons
tend to float in the denser atoms. Therefore, for €œfast€� bass, you should
put the amp BELOW the speakers, so that the electrons can float upwards.

I tell you, there are so many misconceptions out there...

Everybody knows that you should ultrasonically weld the layer of silver
onto the copper wire. Electroplating uses up all the free electrons.


Extends the HF response too.

geoff