On 8/1/2019 3:32 PM, Phil Allison wrote:
Paul wrote:
This one was not powering up, so I cracked it open.
The on-board fuse was still good. There was 120 AC,
and about 330 DC on the first rectifier. But
there were no DC voltages going to the next board.
So it's most likely a power supply issue, but as you
know, modern switching power supplies are very
complex, and are difficult to troubleshoot, especially
without a proper schematic.
Any advice is appreciated.
** Give the job to someone who knows what they are doing and has the needed safety and test equipment.
I have the test equipment....haven't you been paying attention to my
posts?
Yours is definitely a case of " fools rushing in where angels fear to tread".
Yours is definitely a case of "I've got my head up my ass!"
FFS ignore Scott Dorsey, the guy is a dangerous idiot.
Look in the mirror if you wanna see an idiot!