[Captain Howdy]

Wire the subs up series/paralle for a 2 ohm load. Place a jumper from the
positive of coil A to the negative of coil B on each sub. Then wire the
positive of coil B of each sub to the positive of the ampifier and the
negative of coil A of each sub to the negative of the amplifier.

In article .com,
wrote:
Hey whats up guys i have a couple questions. Ok i have a custom box
sealed for my 1990 chevy silverado ext cab frontfiring box sealed at
1.4cb ft on each side, now i bought two Kicker L7`s dual 2 ohm and I
bought a zx1500 mono amp. Should i wire the subs parallel or in a
series. i want to bridge the to subs into one channel.
The l7 are 1500 watts (750 rms) a piece and the amp is 1500 watts.
Please give me some ideas and the way i should do it right.