Phil Allison wrote:

"Chuck Harris" wrote in message
...

There is absolutely no good reason to try and make your speaker wires
8 ohm transmission lines.

** There is - but you are too dumb to see it.

There are more than a few good reasons not to!
One is the capacitance per foot would likely cut your highs.

** What rot.

Another is the impedance of your speakers is only 8 ohms at dc.

** More rot.

And another is the impedance of your amp is only a small fraction of an
ohm.

** Huh ????????????

The reason transmission line matches are important at RF frequencies
is mostly to do with the voltage changes along the line caused by
"standing waves".

** True enough for FRO - but irrelevant for audio and most video lines.

These variations occur at 1/4 wavelength intervals
1/4 wavelength at audio frequencies is on the order of 30,000 meters/4.

** Do you understand the word "irrelevant" ???????

A really long distance. Long enough to be entirely insignificant.

** I am thoroughly sick of arguing with ******wit** ham radio jerk-offs
about transmission lines.

Read closely:

Standing waves are NOT the issue for audio or video, something
**else** is.

That something is capacitance and inductance.

For audio and video *signal* lines cable capacitance attenuates the
high frequencies.

For loud speaker lines cable inductance does the same.

A line impedance matched to its characteristic Z at the receiving
end does NOT lose highs.

Such a line is resistive as a load.

Capice ???????

........... Phil

Prime asshole. An idiot with a teeny little bit of knowledge. Doh.
Let's stop humouring him.

Andy