View Single Post
  #323   Report Post  
Posted to rec.audio.tech,sci.electronics.repair,uk.rec.audio,uk.tech.broadcast,uk.tech.digital-tv
Michael A. Terrell Michael A. Terrell is offline
external usenet poster
 
Posts: 318
Default Audio Precision System One Dual Domani Measuirement Systems


"Dave Plowman (News)" wrote:

In article ,
Michael A. Terrell wrote:

There is no fixed number. It depends on the floor plan of the house.
The only dedicated outlets are for refrigerators, freezers, dryers and
electric stoves.


Think I prefer our system where all of these can be used on any outlet in
the house. Although fixed heating would normally have an individual radial
circuit. As would water heating.



A kitchen electric stove can take up to 50A 240V which is more than
your fragile rings can handle. Who is going to move a dryer from room
to room? The refrigerator or freezer can be plugged in anywhere, but why
would you want them anywhere but the kitchen?


Other circuits can have multiple outlets in a chain.
The maximum per circuit may depend on local code, but a typical breaker
panel is 20 slot and a few are empty for future use.


Local code - and you expect those in the UK to understand it? Why have
different numbers according to what side of a line you live?



Sigh. Water table, salt air, and hundreds of variables that tighten
the standard NEC. Some areas banned BX cable, because it rusts. In
some areas you have to use Schedule 80 gray PVC conduit instead of
steel. There are good reasons for most exemptions, and rules in the
NEC. Some limit the number of rooms per circuit, while others limit the
maximum number of outlets per circuit. There are differences all over
Europe, which is your side of the line.

The first homes to get electricity usually had one outlet per room,
and one ceiling ;light with a pull chain. Two 10 A fuses, and a 15A
main on the 90-110 service. Some areas were DC, some were 25 Hz and
others were 60 Hz. Farms used lead acid batteries and a 'Wincharger' to
charge them. The house was wired for 32 volt, but used standard 110
hardware so that when the grid became available all they had to do was
replace the bulbs and appliances. Now, some areas require new service
or upgrades to be 200A 240V for the main breaker.


--
You can't have a sense of humor, if you have no sense.