On Apr 6, 6:18*pm, "Gareth Magennis"
wrote:
Hi,
I have a Neumann KMR81i here that needs a good clean. *I've dismantled it to
reveal the inner mesh, leaving the shotgun tube with end cap.
Whats the do's and don'ts *to clean both the mesh and the end cap, which is
particularly gunked up?
Cheers,
Gareth.
http://www.neumann.com/?lang=en&id=c...cid=kmr81i_des...
I would soak both the cap & mesh screen in warm soapy water and gently
clean with a soft toothbrush to loosen the gunk. Once the gunk & dirt
are loose/gone rinse with clean water and dry with tissues then let
air dry. You could also use 91% isopropyl alcohol instead of the soap
& water.
Eric