Phil Allison wrote:
"Bob"
IIRC, impedance is turns ratio squared. That would mean that he should
tie the "4 ohm" tap to ground instead of the 8 ohm tap. I would
presume that he wanted the same voltage levels (but 180 degree out of
phase) on both cathodes).
** Correct - the posted ( hypothetical) diagram is wrong on that.
Indeed, the grounded CT of the 16 ohm whole speaker winding should be for
4ohms
from either end, and the 8 ohm connection should be between the shown 4&16
points.
Don't expect diagrams posted on the web to contain correct information
which has all the operating voltages and information relevant.
Patrick Turner.
http://www.nashaudio.com/Public/6550_OUT.pdf
......... Phil