Mike Rivers wrote:
amble wrote:
i'm making a y cable. it is a stereo TRS unbalanced (T-left R-right)
to 2 XLR'S. the shield wire from the TRS splits to go to pin 1 of each
XLR.

should i connect the signal wire (T and R) to pin 2 on the respective
XLR connectors and put a jumper between pins 1 and 3 of each XLR
connector?

Yes. That should work into just about any XLR input. Are the levels
correct? You're not trying to connect a headphone jack to a pair of mic
inputs, are you?

No, its a monitor out from a mixer to a combiner box that feeeds my
monitors. levels should be ok. Thanks mike, I'm glad i guessed it
right on the first try..