[[email protected]]

On Monday, May 8, 2017 at 9:48:31 AM UTC-4, Don Pearce wrote:
On Mon, 8 May 2017 06:34:38 -0700 (PDT), wrote:

On Monday, May 8, 2017 at 9:22:43 AM UTC-4, Scott Dorsey wrote:
In article , Mike Rivers wrote:
On 5/8/2017 8:01 AM, wrote:
1.5A 9VDC supply, $6.95!

RTFMessage! This is a DC power supply (about a hundred of 'em - you
could have linked to the one you thought was the right one). A DC power
supply won't power a device that expects an AC input, at least not with
considerable modification.

I can't say offhand how the numbers work out, but I have two of them running
off a (10V at 1.2A) Triad FP10-1200 flatpack transformer, along with some
crossover electronics that probably take a hundred mA. The Triads are pretty
conservatively rated, they fit into a 1U case, but I think the 1.2A is the
largest one available.

If I was looking for 9 or 10 volts at 1.5A, I would look at the Amveco
(formerly Talema) toroids.
--scott
--
"C'est un Nagra. C'est suisse, et tres, tres precis."

I used to buy standard 12V Xfmrs, and removed secondary turns to whatever I needed. Costly to buy non-standard voltages, 18V CT makes more sense.

Jack

Switchers are dead cheap these days, and frankly they are pretty much
as clean as linears.

I'll admit that true, but I've seen more problems (failures) with switchers than linear.

Jack

d

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus