hi Sascha,
many thanks for the "great person" :-) I just want to help.
Dayner users must stick together!
I did 2 more drawings which I think will clear things up:
http://www.mellowmatic.net/dayner/im...nnections2.gif
Fig. 5 shows the schematic representation of a symmetrical cable,
which I used for all the drawings.
Everything in black (lower line + the 2 squashed circles) is the cable
shield,
the blue and red lines are the 2 wires inside.
Fig. 6 shows the working version, the upper drawing is for stereo
jack, the lower the corresponding one for XLR (like fig. 2).
- The ground on Motu (sleeve on jack, pin 1 on XLR ) is connected to
the cable shield
but also to one of the wires. On the Dayner side only the wire is
connected to the sleeve.
- "Hot" on Motu (tip on jack, pin 2 on XLR ) is connected to the other
wire, which connects to the ring of the dayner jack.
- "Cold" on Motu isn't connected at all.
Some general words:
you said that the problems started when connecting something to the
CRM out.
I would leave the connections to the Motu alone and focus on the
connections on the CRM out.
Your KRK V88 monitors have balanced inputs, so try the connection
scheme on fig. 3.
I did it this way and it helped me a lot!
and again: I hope this helps
greetings,
Pierre
Dayner users must stick together! :-)