Thread: Fisher 30-A amp
View Single Post
  #4   Report Post  
Posted to rec.audio.tubes
Eike Lantzsch, ZP6CGE Eike Lantzsch, ZP6CGE is offline
external usenet poster
 
Posts: 11
Default Fisher 30-A amp

G.Re wrote:
Hi folks,

What is the reason the Fisher 30-A uses (very) different valued grid
resistors for the power tubes?
- R9 = 2K2 for V2
- R4 = 33K for V3
https://www.flickr.com/photos/derekv...n/photostream/

A later (or earlier?) 30-A version has no grid resistors, also no balance
circuit for the phase inverter.

When the EL84 start pulling grid current the difference of
impedance of the cathode side and the anode side of the phase
splitter comes into play. To balance the grid current the anode
side grid resistor is of lower value than the cathode side
resistor. That is careful design. The engineers probably found
out that, for consumer grade equipment, the distortion due to this
effect are negligable compared to the the distortion due to
overload and canceled the resistors to save some cents.
Kind regards, Eike