[[email protected]]

On Thursday, 25 June 1998 12:00:00 UTC+5, wrote:
In article , QuocThai Tran wrote:
Any complains or opinions about a/d/s 850 MX ??
I'm looking to buy one soon.

I have an MX860 in a quadamped setup:
two channels bridged 0-80hz - sub
80-320hz - midbass
320hz-4khz - midrange
4khz - inf - tweeters

It was a mild pain getting the bandpass modules made: the peon who made
them didn't know how to solder a doublesided board without vias and didn't
solder the top side. This caused two drivers to blow the second I turned
on the amp (30VDC== 200+W will do that). Fortuneately the store replaced
them under warranty.

In any case, it is a great sounding amp: very clean, very powerfull.

I'll take it over SS or RF any day. ( I used to have SS before my system
got stolen and a friend has RF )

I hope this message finds you in good health! I was searching for crossover modules for my A/D/S 850MX. While searching I found this thread and wanted to know how I can get the modules for my 850mx