D.Kreft wrote:
500W x 2-Ch @ 4-Ohms Dynamic Music Watts
I don't know what a "Dynamic Music Watt" is.
I don't either! Sure sounds cool, though, doesn't it?
:~)
It doesn't look like you can take your 4-channel amp and run it in
2-channel (bridged) mode on a 4 Ohm load. You'll need to wire the
individual coils in series. See "1 DVC driver with Voice Coils in
Series" at
http://mobile.jlaudio.com/support_pages.php?page_id=161 and do that
twice.
-dan
Then to keep it simple I am going to assume (1) channel and (1) sub
like in the picture. My amp will then be pushing a sub with an 8 Ohm
load. Is this correct? This will not be any cause for me to worry, I
hope.
Thanks!
bob z.