"Eddie Runner" wrote in message
...
| Gary Rodgers wrote:
|
| Each half of the bridged amp will see a 2-ohm load, but the load itself
| doesn't change. 4-ohms is 4-ohms, etc. The "bridged" amp sees the load
as
| it is. 4 ohms.
|
| Gary,
| you recomend a decent web site to answer all the questions here.
| but then you state exactly the opposite.... ha ha ha

Where? It says the bridged amp (complete circuit) sees the load just as it
is - 4 ohms? A load is a load...now, when you look at the circuit and the
way it is derived (bridged), each side of the bridge is acting as it would
with a 2 ohm load...


Gary