Dont forget to factor in the total system impedence (Sub + enclosure)
The amp 'may' not be seeing that low of an impedence load. Im running
my amps at 2 ohms bridged with an aperiodic enclosure, the amps get warm
but not at all hot pushing techmaster peb. Then again I dont listen to
it that loud for long periods.

Garrett

Mark Zarella wrote:

If there was a problem, it would be with the amp, not with the subs. You


have


them wired at 2 ohm mono, and your amp is rated to 2 ohm stereo. I'm not


sure


what overall affects that can have on the amp... I've done it before and


the


amp would overheat and shut down.



In short, it's not good for the amp if it starts shutting down. Yet he
didn't complain about that happening, so who knows what's going on...