View Single Post
  #14   Report Post  
Posted to rec.audio.pro
geoff geoff is offline
external usenet poster
 
Posts: 1,812
Default [OT] Adding volume control to electronic device

On 14/01/2021 4:52 am, Scott Dorsey wrote:
gray_wolf wrote:

Remember the old drive in movie theater speakers with the volume control?=


Those were 70V system. 70V constant power going down the cable, each tap
has a step-down transformer, then an L-pad (not a simple pot but a three
element pad so the transformer always sees an 8 ohm load) and a crappy
speaker.


Not switched tapped transformers ?

Because they were all parallel loads, if the main cable was shorted
by someone driving away without removing the speaker, it would take
all of them down.


A bit like any singel speaker cable system in that regard !

geoff