Bourns Pot Shafts Not Long Enough!
Paul wrote:
I have ordered a few of the 2K Bourns pots, with the intention
of taking apart one of them, and seeing if I can replace the too-short
new shaft, with the older, but longer shaft.
** That seems worth a try.
It might work. If it doesn't, I'll just cut a slot in the shaft,
and use a screwdriver to adjust it, as has been suggested.
** Once came across some fancy pots that uses 1/8inch metal shafts - but original knobs were missing.
So, I converted /4 inch, plastic knitting needles into sleeves by drilling 1/8 inch holes up the centre of a few short pieces. Standard knobs then fitted fine.
..... Phil
|