[jtougas[_3_]]

Hi folks -

I picked one of these up a few years ago, and while I've always liked
the delay portion of it, the reverb always sounded a little weak. So,
acting on impulse, I pulled out the little 2 or 3 inch long reverb
tank, and riveted in a 9 inch Accutronics from a Carvin amp that had
recently gone up in smoke (not my fault, I never touched the insides
of it! - shame, too, great sounding amp).

So, now the reverb tails off much more nicely, and sounds better, only
it's much more dim than it was before.

So, what do I need to do to the circuit now? Replace some caps? Change
out a potentiometer? Both? Neither?

Look somewhere else? *grin*

Any leads would be appreciated.

Thanks -
--
jtougas

"listen- there's a hell of a good universe next door
let's go" - e.e. cummings