On 6/15/2019 2:30 AM, Paul wrote:
You won't believe this:Â* It was something like a 24 pin
header, with only 12 of the pins connected!
It's an easy mistake to make if the connector is in a tough-to-see spot,
as many of them are. I've seen socketed DIP ICs installed with one row
of pins all on the outside of the socket.
Â*Â*Â*Â*Â* But I've never had a keyboard with an after-touch strip.Â* I must
say I don't really like it.
. . . . how the aftertouch affects the voices, in some cases, it either adds
a vibrato, or makes the note louder, or both.Â* Doesn't seem too useful,
musically, but then again, it would depend of the kind of music you want
to create. I hope there is an easy way to turn the aftertouch off!
I don't know if there's a way to globally turn off aftertouch (you could
disconnect the strip, I suppose), but it's almost certainly a parameter
in the patch that creates the voice. Factory presets are usually created
to show off as many features of the instrument as possible. Get into the
patch editor and you'll probably find how to change what it modulates,
or turn it off in that patch.
Or just don't press the keys so hard.
--
For a good time, call
http://mikeriversaudio.wordpress.com